Режим работы:
Пн.-Пт.: с 10 до 19 часов

Прием заказов online:
круглосуточно без выходных

Телефон:
+38-(050) 967-02-74

Viber:
050 9670274

e-mail:
sale@hi-ip.com

Мы ждем Ваши отзывы о нашей работе на
Facebook

 

Твердотельное реле времени OMRON H3CR-A (1.2 sec - 300 h AC 100-240V)

Твердотельное реле времени OMRON H3CR-A (1.2 sec - 300 h AC 100-240V)

Производитель: OMRON
Модель: H3CR-A
Наличие: Есть в наличии
Цена: 821.74₴
Количество:     - или -   в закладки
сравнение
  • Диапазон1.2с-300часов
  • Наибольшая погрешность1% от полной шкалы
  • Напряжение питания100-240 V AC
  •  
  • Размеры (высота-ширина-глубина)48 x 48 x 93,5мм
  • Тип клеммных колодокНа Din-рейку: PF083A-E 
    На панель: Y-40 и US-08 или Y-40 и P3G-08
 

 

 

Item H3CR-A/-AS/-A-301 H3CR-AP H3CR-A8/-A8S/-A8-301 H3CR-A8E
Operating mode A: ON-delay 
B: Flicker OFF start 
B2: Flicker ON start 
C: Signal ON/OFF-delay 
D: Signal OFF-delay 
E: Interval 
G: Signal ON/OFF-delay 
J: One-shot
A: ON-delay (power supply start) 
B: Flicker OFF start (power supply start) 
B2: Flicker ON start (power supply start) 
E: Interval (power supply start) 
J: One-shot (power supply start)
Pin type 11-pin 8-pin
Input type No-voltage input Voltage input ---
Time-limit output type H3CR-A/-A8/-AP/-A-301/-A8-301: Relay output (DPDT)  Relay output 
Instantaneous output 
type
--- Relay output 
(SPDT)
Mounting method DIN track mounting, surface mounting, and flush mounting
Approved standards UL508, CSA C22.2 No.14, NK, Lloyds, CCC 

Time Ranges

 

Note: When the time setting knob is turned below "0" until the point where the time setting knob stops, the output will 
          operate instantaneously at all time range settings. 
Time unit s (sec) ×10 s (10 sec) min (min) ×10 min (10 min) h (hrs) ×10 h (10 hrs)
Full scale 
setting
1.2 0.05 to 1.2 1.2 to 12 0.12 to 1.2 1.2 to 12 0.12 to 1.2 1.2 to 12
3 0.3 to 3 3 to 30 0.3 to 3 3 to 30 0.3 to 3 3 to 30
12 1.2 to 12 12 to 120 1.2 to 12 12 to 120 1.2 to 12 12 to 120
30 3 to 30 30 to 300 3 to 30 30 to 300 3 to 30 30 to 300
Rated supply voltage 
*1 *2
100 to 240 VAC (50/60 Hz)/100 to 125 VDC, 24 to 48 VAC (50/60 Hz)/ 
12 to 48 VDC (24 to 48 VAC/VDC for H3CR-A8E) *3
Operating voltage range 85% to 110% of rated supply voltage (90% to 110% at 12 VDC)
Power reset Minimum power-opening time: 0.1 s
Input No-voltage Input 
ON impedance: 1 kΩ max. 
ON residual voltage: 1 V max. 
OFF impedance: 100 kΩ min. 
Voltage Input 
Max. permissible capacitance between inputs lines (terminals 6 and 7): 1,200 pF 
Load connectable in parallel with inputs (terminals 6 and 7). 
100 to 240 VAC/100 to 125 VDC 
High (logic) level: 85 to 264 VAC/85 to 137.5 VDC 
Low (logic) level: 0 to 10 VAC/0 to 10 VDC 
24 to 48 VAC/12 to 48 VDC 
High (logic) level: 20.4 to 52.8 VAC/10.8 to 52.8 VDC 
Low (logic) level: 0 to 2.4 VAC/0 to 1.2 VDC
Power consumption H3CR-A/-A8 
100 to 240 VAC/100 to 125 VDC (When at 240 VAC, 60 Hz) 
Relay ON: approx. 2.0 VA (1.6 W), Relay OFF: approx. 1.3 VA (1.1 W) 
24 to 48 VAC/12 to 48 VDC (When at 24 VDC) 
Relay ON: approx. 0.8 W, Relay OFF: approx. 0.2 W 
H3CR-AP *3 
100 to 240 VAC/100 to 125 VDC (When at 240 VAC, 60 Hz) 
Relay ON: approx. 2.5 VA (2.2 W) *4, Relay OFF: approx. 1.8 VA (1.7 W) *4 
24 to 48 VAC/12 to 48 VDC (When at 24 VDC) 
Relay ON: approx. 0.9 W *4, Relay OFF: approx. 0.3 W *4 
H3CR-A8E 
100 to 240 VAC/100 to 125 VDC (When at 240 VAC, 60 Hz) 
Relay ON/OFF: approx. 2 VA (0.9 W) 
24 to 48 VAC/VDC (When at 24 VDC) 
Relay ON/OFF: approx. 0.9 W 
Control outputs Models with Contact Outputs 
H3CR-A/-A8/-AP 
5A at 250 VAC/30 VDC, 0.15A at 125 VDC, resistive load (cosφ = 1) 
Minimum applied load: 10mA at 5 VDC (failure level: P reference value) 
Contact materials: Ag-alloy 
H3CR-A8E 
5A at 250 VAC/30 VDC, 0.15A at 125 VDC, resistive load (cosφ = 1) 
Minimum applied load: 10mA at 5 VDC (failure level: P reference value) 
Contact materials: AgSnIn 

*1. DC ripple rate: 20% max. (A single-phase, full-wave-rectification power supply can be used). 

*2. Do not use an inverter output as the power supply. Refer to your OMRON website for details. 
*3. Models with 24-to-48-VAC or 12-to-48-VDC power supply have inrush current. Caution is thus required when turning 
       ON and OFF power to the Timer with a non-contact output from a device such as a sensor. (Models with an inrush 
       current of approximately 50 mA and a 24-VDC power supply are available (the H3CR-A-302 and H3CR-A8-302).) 
       For details, consult your OMRON sales representative. 
*4. The values are for when the terminals 2 and 7 and terminals 10 and 6 are short-circuited, and include the 
       consumption current of the input circuit. 
 
 
 
 
Спецификация
 
 
 
 
 
 
 
 
 
 
 
Гарантия

 

Нет отзывов

Написать отзыв

Ваше Имя:


Ваш отзыв: Внимание: HTML не поддерживается! Используйте обычный текст.

Оценка: Плохо           Хорошо

Введите код, указанный на картинке:



Метки: Реле, время
С этим товаром также покупают
Все права защищены © 2022